Bogen WV100 Bedienungsanleitung

Wall-Mount Power Vector AmplifiersWV100, WV150, & WV250 ModelsInstallation and Use Manual© 2002 Bogen Communications, Inc.All rights reserved.Spec

OperationFront Panel Controls & IndicatorsInput Volume ControlsEach input module may be individually controlled by its correspondingvolume contro

OperationOutput LimiterThe Output Limiter control sets the threshold at which the unit hardlimits the output signal. Once the Limiter's threshold

Block Diagram10

Specifications11Power Output (RMS): WV100: 100W (140W Typical, @1 kHz/0.1%/4Ω)WV150: 150W (200W Typical, @1 kHz/0.1%/4Ω)WV250: 250W (340W Typical,

Troubleshooting12• Amplifier not plugged in.• AC outlet dead.• Power switch off.• Circuit breaker tripped.• Speaker connections on amplifier are incor

Warranty13Bogen Wall-Mount Power Vector Amplifiers, modules, and components are warranted to be free from defects in mate-rial or workmanship provided

50 Spring Street, Ramsey, NJ 07446, U.S.A.Tel. 201-934-8500, Fax: 201-934-9832, www.bogen.com

NoticeEvery effort was made to ensure that the information in thisguide was complete and accurate at the time of printing.However, information is subj

ContentsPagePANEL DESCRIPTIONS...2-3Wall-Mount Power Ve

Panel DescriptionsWall-Mount Power Vector Front Panel1. Input Volume ControlEach of the 8 module bays are controlled by an independent volume control

Panel DescriptionsWall-Mount Power Vector Module Bay (Rear)1. Module BaysThe amplifier has eight module bays, all of which can accommodate input modul

InstallationPackage Contents• Amplifier • 2 Cables• Instruction Manual • Combined XLR receptacle and phone jack• 2 Screws (M 3 x 8) • 6 Screws (M 4 x

ModulesModule InstallationEight module bays are available to accept Bogen’s new advanced plug-in input modules. Module bays 7 & 8 canalso accommod

ConnectionsSpeakersTransformer-Coupled Speaker ConnectionsTransformer-coupled, constant voltage speaker loads are connected totheir respective load ty

ConnectionsCOM and GND TerminalsA shorting jumper typically connects the COM and GND terminals ofthe amplifier together. The COM terminal is a common