Bogen HFSF1 Bedienungsanleitung PDF herunterladen (Seite 4)

Installation

Important Notes

The HFSF1 can be installed in a variety of ceiling environments. The use of the TBSF

(Tile Bridge Support) accessory may be desired.

For suspended ceilings, the use of both the TBSF Tile Bridge and CK10 Safety

Cable is strongly recommended to help support and distribute the weight of the

speaker.

The HFSF1 requires a minimum of 7-1/8" of vertical clearance between the front of

the mounting surface and any other structure for the speaker to fit.

The edge of the hole must be a minimum of 1-1/4" away from any side obstructions to

ensure that they will not interfere with the action of the clamps.

Beginning Installation

1. Begin by cutting a 6-1/4" circular hole where the speaker will be installed. A card-

board template is provided with the HFSF1 and should be used as a guide for

making the cutout in the ceiling or sheetrock.

2. Tighten the mounting clamps by turning the clamping screws clockwise. Do not over-

tighten the clamps – only tighten until the speaker is snug in the mounting hole.

If using an electric driver, set the clutch on the driver to the lowest setting.

1 2 3 4 5 6 7 8

Keine Kommentare

Bogen HFSF1 Bedienungsanleitung Seite 4